That said the hole is the least of your effort.
Cut hole vinyl siding.
Clean the siding around the hole with vinyl siding cleaner or dish detergent and water then dry the siding.
A siding zip tool pops the piece off from the bottom edge.
Cover the hole from the back side with foil tape then put the siding back where it belongs.
Make the line as dark as possible so it s visible when you re cutting it.
Mark the line you want to cut on the siding with a pencil.
Place a strip of siding on the work table and align the place you plan to cut it with the edge of the table.
For the smoothest cuts put the blade in.
Holes an inch or two across or long narrow holes that still appear patchable require removing the damaged piece of vinyl to fix it.
A clean way to cut vinyl siding is to score it with a utility knife and then bend the vinyl at the score.
Use tin snips or a rotary tool to make curved cuts.
Not just any circular saw blade will do.
Follow these steps on how to cut vinyl siding with a circular saw.
Use a carpenter s square to draw the line straight.
Fit a circular saw with a fine toothed plywood cutting blade.
When making longitudinal cuts score with a knife and break along the score line.
A hole saw tin snips etc will slice right through it.
You ll need a fine tooth plywood saw blade to do this correctly.
Cutting the vinyl siding is easy.
Make crosscuts on vinyl siding using a circular saw but you should install a vinyl cutting blade to minimize chip out.
First lay a strip of vinyl siding onto a flat and clean working table.
Cut a scrap piece of siding to a length that is several inches longer than the hole.
The best way to cut vinyl siding circular saw.
Using a circular saw is the first method that you can use to cut vinyl siding.
With a pencil and measuring tape mark.
This is a trick on how to cut vinyl siding the quickest and easiest way without breaking or chipping it.
Place that strip of vinyl siding so that the piece and the line you want to cut are slightly off the.
If you re cutting dark vinyl siding use chalk or light colored tape to mark the line you want to cut.
I would cut from the outside on top of the vinyl siding not sure where you are if it s too cold outside but the vinyl siding may crack beyond the hole s diameter you are trying to cut it from the inside.
It should snap apart.
This method is best for cutting a lot of short or long vertical cuts since the circular saw will create clean incisions relatively quickly.
